Epson EB-X31 User Manual

74
Color Difference Correction when Projecting from Multiple Projectors
a
Aim the remote control at the target projector and press the [ID]
b
While holding the [ID] button, press the number button that matches
button. the ID of the projector you want to operate.
The current Projector ID is displayed on the projected screen. It
disappears after about 3 seconds.
The projector you want to operate is selected.
c
Press the [ID] button to check if the ID-setting process worked.
You see a message displayed by the projector.
• If the remote control is listed as On, you can operate the projector
from the remote control.
• If the remote control is listed as Off, you cannot operate the projector
from the remote control. Repeat the steps above to enable the remote
control.
• You must select the projector ID from the remote control each
time you turn on the projector you have set it to control. When
a
you turn on the projector, 0 is selected as the remote control's
projector ID.
• When you set the Projector ID setting to Off, you can operate
the projector using the remote control whichever ID you select
on the remote control.
• When you select 0 on the remote control, you can operate all
projectors regardless the Projector ID setting.

Epson EB-X31 Specifications

General

Projection Technology	3LCD
Resolution	XGA (1024 x 768)
Contrast Ratio	15000:1
Lamp Life Normal	5000 hours
Lamp Life ECO	10000 hours
Projection Ratio	1.48 - 1.77:1
Zoom	1.2x
Screen Size	30 inches - 300 inches
Weight	2.4 kg
Brightness	3200 lumens
Keystone Correction	Vertical ±30 degrees, Horizontal ±30 degrees
Inputs	HDMI, VGA, USB 2.0 Type A, USB 2.0 Type B, Composite
Output Ports	VGA
Security	Kensington lock, Password protection
Color Modes	Dynamic, Presentation, Cinema, sRGB, Blackboard