Installation Settings
Setting the direction
When installation is complete, set the Direction in the Configuration menu
according to the vertical installation angle.
Attention
Make sure you set the Direction correctly. Otherwise the lamp's operating life
may be reduced significantly.
a
When performing portrait projection, you do not need to set the
Direction.
a
Press the [ ] button to turn on the projector.
If the images are out of focus, press the [Focus] button to adjust.
s "Adjusting the Focus" p.37
b
Press the [Menu] button.
c
Select Direction from Extended.
d
Press the [ ][ ] buttons to select the installation angle based on
the direction of the projector, and then press the [
] button.
1
2
3
4
5
A
Pointing Up
B
Angled Up
C
Normal
D
Angled Down
E
Pointing Down
e
When the settings are complete, press the [Menu] button.
Installing the Projector
30
To Next Page
Loading...
