Epson EB-Z10005U - ID Settings; Setting the Projector ID; Checking the Projector ID

ID Settings
When an ID is set for the projector and the remote control, you can use
the remote control to operate only the projector with a matching ID. This
is useful when you use multiple projectors together.
a
• Operation using the remote control is possible only for projectors
that are within the operating range of the remote control.
s "Remote control operating range" p.24
• When Remote Control Type is set to Simple from Operation -
Advanced in the Configuration menu, you cannot set the remote
control ID.
s "Extended Menu" p.122
• IDs are ignored when the projector ID is set to Off or the remote
control ID is set to 0.
Setting the projector ID
a
Press the [Menu] button while projecting.
b
Select Multi-Projection from Extended.
c
Select Projector ID, and then press the [ ] button.
d
Select the ID you want to set, and then press the [ ] button.
e
Press the [Menu] button to close the Configuration menu.
Checking the projector ID
During projection, press the [Help] button while holding down the [ID]
button.
Remote control
When you press the buttons, the current projector ID is displayed on the
projection screen. It closes after about three seconds.
Installing the Projector
39