Epson EB-Z10005U - Setting the Remote Control ID

Setting the remote control ID
a
Set the remote control [ID] switch to On.
b
While holding down the [ID] button, press the number of the ID
for the ID of the projector you want to operate.
s "Checking the projector ID" p.39
Remote control
Once this setting has been made, the projector that can be operated by the
remote control is limited.
a
The remote control ID setting is saved in the remote control. Even if
the remote control batteries are removed to replace them and so on,
the stored ID setting is retained. However, if the batteries are left out
for a long time, it is reset to the default value (ID0).
Installing the Projector
40