Connecting an HDBaseT Transmitter
Connect the optional HDBaseT transmitter with a commercially available 100BASE-TX LAN cable.
s "Optional Accessories" p.198
a
• Make sure you read the User's Guide supplied with the HDBaseT transmitter carefully before use.
• Use a category 5e or category 6 shielded LAN cable.
• When connecting or disconnecting the LAN cable, make sure you turn off the power for the projector and the HDBaseT transmitter.
• When performing Ethernet communication or serial communication, or when using the wired remote control via HDBaseT port, set Control Communications
to On in the Configuration menu.
s Extended - HDBaseT - Control Communications p.122
Note that when Control Communications is set to On, the projector's LAN port, RS-232C port, and Remote port are disabled.
• When using the Extron XTP transmitter or switcher, connect to the projector's HDBaseT port. Set Extron XTP to On (Standby Mode and Control
Communications are automatically set to On).
s Extended - HDBaseT - Extron XTP p.122
Connecting Equipment
46
To Next Page
Loading...
