Using the Edge Blending Function
When multiple projectors are lined up and projecting images, you can
create a seamless screen.
Make the following settings on the Edge Blending menu, to correct the
image.
Sub Menu Function
Edge Blending Set to On to activate the edge blending function. Set to Off
when not projecting from multiple projectors.
Top Edge/Bottom Edge/
Right Edge/Left Edge
Blending: Set to On to activate the edge blending function
towards where you are setting, and the brend range will be
shaded.
Blend Range: Adjusts the range to be shaded. Adjustment
is possible at the level of one pixel. The maximum range is
45% of resolution.
Blend Curve You can select from three ways of shading.
Black Level When projecting a dark image, correct the part that is not
overlapped to resolve the brightness of overlapped part.
Brightness Correct.: Adjust the brightness of the range
that is not shaded.
Color Correct. (G/R): Adjust the color tone of the range
that is not shaded to greenish and reddish.
Color Correct. (B/Y): Adjust the color tone of the range
that is not shaded to bluish and yellowish.
Guide Display Set to On to display the guide on the edge blending setting
range.
Guide Colors You can select the combination of guide colors from the
three.
Procedure
A
Press the [Menu] button and select Extended menu - "Multi-
Projection" from the configuration menu.
s "Using the
Configuration Menu" p.47
Remote Control
B
Select "Edge Blending", and then press the [Enter] button.
C
Turn on "Edge Blending".
(1) Select Edge Blending, and then press the [Enter] button.
(2) Select On, and then press the [Enter] button.
(3) Press the [Esc] button.
Settings for Multiple Projectors
155
To Next Page
Loading...
