D
Move the box to select the part of the image to use as the
User's Logo.
Using the Remote Control Using the Control Panel
q
You can save at up to 400 ^ 300 dots in size.
E
When "Select this image?" is displayed, select "Yes".
F
Select the zoom factor from the zoom setting screen.
400% is displayed only when using EB-Z8455WU/Z8450WU.
G
When the message "Save this image as the User's Logo?" is
displayed, select "Yes".
The image is saved. After the image has been saved, the message
"Completed." is displayed.
q
• To use the saved user's logo as the screen image, set it in the
Display settings under the Extended menu. s p.57
• When a User's Logo is saved, the previous User's Logo is erased.
• Saving the user's logo may take approximately 15 seconds. Do not
use the projector or any connected equipment while it is saving,
otherwise malfunctions may occur.
Saving a User's Logo
37
To Next Page
Loading...
