Sub Menu Function
Remote Receiver
You can limit the reception of the operation signal from the remote control.
When you want to prohibit operation by remote control, or if the remote receiver has a fluorescent light too close to it, you can make
settings to deactivate the remote receiver you do not want to use or that is experiencing interference.
If the [Menu] button on the remote control is pressed for 15 seconds, this parameter will return to the default setting.
User Button
You can select the item assigned from the configuration menu with the remote control's [User] button. By pressing the [User] button the
assigned menu item selection/adjustment screen is displayed, allowing you to make one-touch settings/adjustments. You can assign one of
the following items to the [User] button.
Power Consumption
*
, Info, Progressive, Test Pattern, Multi-screen, Resolution, Memory
Test Pattern
When the projector is setup, a Test Pattern is displayed so that you can adjust the projection without connecting other equipment.
s p.137
Memory
Load Memory: Recalls the setting value registered in Save Memory. s p.45
You cannot select if nothing is registered by Save Memory.
Save Memory: Registers settings related to the image in the configuration menu as memory.
s
p.44
Erase Memory: Deletes unnecessary memories.
s
p.45
Rename Memory: Changes the name of the registered memory. s p.45
Reset
You can reset all adjustment values on the Settings menu to their default settings, except for User Button and Memory.
To return all menu items to their default settings, see s p.79
* EB-Z8455WU/Z8450WU/Z8355W/Z8350W/Z10005/Z10000 only
Settings Menu
56
To Next Page
Loading...
