Sub Menu Function
Channel
You can select the channels used to connect in Quick mode. If interference from other signals occurs, use a different channel.
SSID Display
To prevent the SSID from being displayed on the LAN Standby screen, set this to Off.
DHCP
You can set whether or not (On/Off) to use
DHCP
g
.
If this is set to On you cannot set any more addresses.
IP Address
You can input the IP address
g
assigned to the projector.
You can input a number from 0 to 255 in each field of the address. However, the following IP addresses cannot be used. 0.0.0.0, 127.x.x.x, 224.0.0.0 to
255.255.255.255 (where x is a number from 0 to 255)
Subnet Mask
You can input the
Subnet Mask
g
for the projector. You can input a number from 0 to 255 in each field of the address. However, the following subnet
masks cannot be used.
0.0.0.0, 255.255.255.255
Gateway Address
You can input the IP address for the gateway for the projector.
You can input a number from 0 to 255 in each field of the address. However, the following
Gateway addresses
g
cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
IP Address Display
To prevent the IP address from being displayed on the LAN Standby screen, set this to Off.
Region Code
This is a specific string of the wireless LAN module.
Network Menu
64
To Next Page
Loading...
