b
Press the [h] button on the remote control in the [ ][ ] direction
or press the [Enter] button on the control panel to switch the test
pattern.
Using the remote control Using the control panel
The following image adjustments can be made while the test pattern
is being displayed.
Top Menu Name Sub Menu/Items
Image
Color Mode
Abs. Color Temp.
Advanced
- Gamma
*
- RGB
- RGBCMY
Reset
Signal
Auto Setup
Settings
Geometric Correction s p.34
Extended
Multi-Projection s p.38
- Brightness Level
*2
- Edge Blending
- Multi-screen
*1 Except for custom settings of gamma
*2 EB-Z8455WU/Z8450WU/Z8355W/Z8350W/Z10005/Z10000 only
a
To set menu items that cannot be set while the test pattern is
being displayed or to fine-tune the projected image, project an
image from the connected device.
Installing the Projector
24
To Next Page
Loading...
