Epson EB-Z8455WU - Adjusting the Position of the Projected Image (Lens Shift)

Top Menu Sub Menu/Items
Reset
Signal menu Auto Setup
Settings menu Geometric Correction s p.139
Extended menu Multi-Projection
- Brightness Level
*2
- Edge Blending s p.155
- Multi-screen s p.157
*1 Except for custom settings of gamma
*2 EB-Z8455WU/Z8450WU/Z8355W/Z8350W/Z10005/Z10000 only
q
To set menu items that cannot be set while the test pattern is being
displayed or to fine-tune the projected image, project an image from
the connected device.
C Press the [Esc] button to end the test pattern.
Adjusting the Position of the Projected Image
(Lens Shift)
The lens can be shifted to adjust the position of the projected image, for
example, when the projector cannot be installed directly in front of the
screen.
Procedure
A Press the [Lens Shift] button on the Remote Control. When
using the control panel of the projector, press the [Lens]
button three times.
Using the Remote Control Using the Control Panel
B To adjust the position of the projected image, use the [h]
button on the remote control or the [
w/ ], [v/ ], [</ ],
and [
>/ ] buttons on the control panel.
Using the Remote Control Using the Control Panel
Keep pressing the button to move the image continuously.
When the position of the lens shift comes to the center of the vertical
or horizontal direction, it stops moving. Release your finger and press
the button again to adjust more.
Adjusting the Projected Image
138