q
The image will be clearest when both the vertical and horizontal lens
shift are set in the center.
The ranges within which the image can be moved are shown below.
*1 EB-Z10005/Z10000/Z8150: V x 56%
*2 EB-Z10005/Z10000/Z8150: H x 6%
A
Center of lens
B
Projected image when lens shift is set in the center
The position of the projected image cannot be moved to the both
horizontal and vertical maximum value.
Example: When the image is moved to the maximum value horizontally,
that can be moved up to 50% vertically. When the image is moved to the
maximum value vertically, the image cannot be moved horizontally.
Adjusting the Tilt of the Projected Image
When setting up on a desk, adjust the horizontal tilt of the projector with
its front and rear feet.
Correcting Distortion in the Projected Image
There are four methods of correcting distortion in projected images as
below.
• Quick Corner
This allows you to manually correct each of the four corners of the
projected image separately.
s "Quick Corner" p.140
We recommend using Quick Corner to accurately adjust keystone
distortion.
• H/V-Keystone
This allows you to manually correct distortion in the horizontal and
vertical directions independently. You can perform easy H/V-Keystone
corrections by using the [
w/ ] [v/ ] [</ ] and [>/ ] buttons on
the projector's control panel.
s "H/V-Keystone" p.142
Adjusting the Projected Image
139
To Next Page
Loading...
