Items that can be set vary depending on the image signal or input source currently being projected as shown in the following screen shots. Setting details are
saved for each image signal.
You cannot make settings in the Signal menu other than Scale when the input source is LAN.
RGB Signal Component Video Signal
g
Composite video Signal
g
/S-Video
Signal
g
HDMI/SDI
*
*
EB-Z8455WU/Z8450WU only
Sub Menu Function
Auto Setup
You can select whether or not (On/Off) Auto Setup automatically adjusts the image to the optimum state when the input signal changes.
Resolution
Auto: The resolution of the input signal is automatically identified.
Wide, Normal: If the images cannot be projected correctly when Auto is set, set this menu. Set to Wide depending on the connected
computer for wide screens, or set to Normal for 4:3 or 5:4 screens.
Manual: You can specify the resolution. This is ideal when connected computer is fixed.
Tracking
g
You can adjust computer images when vertical stripes appear in the images.
Sync.
g
You can adjust computer images when flickering, fuzziness, or interference appear in the images.
Position
You can adjust the display Position up, down, left, and right when a part of the image is missing so that the whole image is projected.
Progressive
Off: IP conversion is carried out for each field in the screen. This is ideal for viewing images with a large amount of movement.
Video: This is ideal for viewing general video images.
Film/Auto: By automatically converting movie films, CG, animated images, and so on recorded in 24/30 frames to the optimum progressive
signal via 2-3 pull-down, it is possible to recreate the natural feel of the original image.
Frame Interpolation
*
You can play fast moving images smoothly by producing intermediate frames between the original frames.
Super-resolution
To display a crisp image, you can reduce the blurring that is created on the edge when the image data is scaled up to fit the panel resolution
of the image signal.
Signal Menu
53
To Next Page
Loading...
