E
Indicates the projection lamps status.
Flashes green while Shutter or Blank is activated.
Refer to the following table to see what the indicators mean and how to remedy problems that they indicate.
If all indicators are off, check that the power cable is connected correctly and that the power is being supplied normally.
Sometimes, when the power cable is unplugged, the
t indicator remains lit for a short period, but this is not a fault.
t
Indicator is lit or flashing red
: Lit : Flashing : Off
Status Cause Remedy or Status
Internal Error Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest
address provided in the Support and Service Guide. s Epson Projector Contact List
Fan Error
Sensor Error
Cool System Error
Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest
address provided in the Support and Service Guide. s Epson Projector Contact List
High Temp Error
(overheating)
The lamps turn off automatically and projection stops. Wait for about five minutes. After about five minutes the projector
switches to standby mode, so check the following two points.
• Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall.
• If the air filter is clogged, clean or replace it. s p.98, p.104
If the error continues after checking the points above, stop using the projector, disconnect the power cable from the electrical
outlet, and contact your local dealer or the nearest address provided in the Support and Service Guide. s Epson Projector
Contact List
When using at an altitude of 1500 m or more, set High Altitude Mode to On. s p.57
Set Direction to Pointing Down, Pointing Up, Angled Up, or Angled Down when the projector is installed in a direction
which is not horizontal. s p.57
Lamp Error
Lamp Failure
Check the following two points.
• Take out the both lamps and check if they are cracked. s p.101
• Clean the air filter. s p.98
Problem Solving
84
To Next Page
Loading...
