Edges of the Image are Cropped During Borderless Copying
Because the image is slightly enlarged, the protruding area is cropped.
Solutions
Select a smaller enlargement setting.
Select Copy > Advanced Settings > Borderless Copy > Expansion on the control panel, and then change
the setting.
The Position, Size, or Margins of the Copies are Incorrect
e
following causes can be considered.
The paper is loaded incorrectly.
Solutions
Load paper in the correct direction, and slide the edge guide against the edge of the paper.
& “Loading Paper” on page 29
The size of the paper is set incorrectly.
Solutions
Select the appropriate paper size setting.
The originals are not placed correctly.
Solutions
❏ Make sure the original is placed correctly against the alignment marks.
❏ If the edge of the scanned image is missing, move the original slightly away from the edge of the
scanner glass. You cannot scan the area within approximately 1.5 mm (0.06 in.) from the edge of the
scanner glass.
& “Placing Originals” on page 31
Solving Problems
>
Printing, Copying, and Scanning Quality is Poor
>
Copy Quality is Poor
176
To Next Page
Loading...
