Troubleshooting
108
Image colors are not right
Check Remedy
Is the image signal format setting correct? When Video is input
If nothing is projected even when Video Signal is set to Auto
from the Configuration menu, set the signal that matches the
connected device.
s Settings - Input Signal - Video Sig-
nal p.91
When Component is input
If nothing is projected even when Component is set to Auto
from the Configuration menu, set the signal that matches the
connected device.
s Settings - Input Signal - Compo-
nent p.91
Are the cables connected correctly?Check that all the cables required for projection are securely
connected.
s p.20
For the Video and Component ports, make sure the connector is
the same color as the cable port.
s p.21
Is the contrast adjusted correctly?
Adjust the Contrast setting from the Configuration menu.
s Image - Contrast p.86
Is the color adjusted correctly?
Adjust the Advanced setting from the Configuration menu.
s Image - Advanced p.86
(Only when projecting images from a video
device)
Are the color saturation and tint adjusted cor-
rectly?
Adjust the Color Saturation and Tint settings from the Config-
uration menu.
s Image - Color Saturation/Tint p.86
Images appear dark
Check Remedy
Is the image brightness set correctly?
Adjust the Brightness setting from the Configuration menu.
s Image - Brightness p.86
Is the contrast adjusted correctly?
Adjust the Contrast setting from the Configuration menu.
s Image - Contrast p.86
Projection stops automatically
Check Remedy
Is Sleep Mode enabled?
If the set time is exceeded and no signal is input, the laser turns
off automatically, and the projector enters standby status. The
projector returns from standby status when you press the
button on the remote control or the button on the control
panel. Do not look into the laser when returning from standby
status. If you do not want to use Sleep Mode, change the setting
to Off.
s Settings - Operation - Sleep Mode p.91
To Next Page
Loading...
