Preparing
20
Connecting a Device
Attention
•
Make cable connections before connecting to a power outlet.
•
Check the shape of the cable's connector and the shape of the port, and then connect. If you force a connector
of a different shape into the port, it could cause damage and a malfunction to occur.
Removing the Cable Cover
You can attach the cable cover to the rear of this projector to give it a clean and smooth look. Remove the
cover when connecting devices using cables, or when replacing the air filter.
a
Loosen the screws at the lower edges of the cable cover, and then pull it forward.
b
Lift the cable cover out of the grooves at the top.
To attach the cable cover, perform this procedure in reverse.
To Next Page
Loading...
