Preparing
24
Connecting to the LAN port
Connect to a network router, a hub, and so on, with a 100BASE-TX or 10BASE-T LAN cable.
You can operate the projector or check its status over a network from a computer or a smart device.
c
•
To prevent malfunctions, use a category 5 or higher shielded LAN cable.
•
You cannot project images over a network.
Securing Cables with the Cable Clamp
You can use the cable clamp to secure cables that have been connected to the projector.
a
Open the cable clamp.
Press the surface of the clamp gently with
your finger to release the tab, and then pull
it to swing it open.
b
Gather the cables into the cable
clamp.
You can gather all cables except for the
power cord into the cable clamp.
c
Close the cable clamp.
Press until the tab clicks into place.
To Next Page
Loading...
