Using the Projector on a Network
52
h
Assign an IP address to the projector as necessary.
•
If your network uses DHCP, select IP Settings to set the DHCP setting to On.
•
If you are not using DHCP, select IP Settings to set the DHCP setting to Off, and then enter the projector's IP
Address, Subnet Mask, and Gateway Address.
i
When you have finished making settings, select Complete and follow the on-screen
instructions to save your settings and exit the menus.
j
Press the source button on the remote control or the [Source] button on the control panel,
and then select LAN.
The settings are complete when you see the correct IP address on the LAN standby screen.
When you have finished making wireless settings for your projector, you need to make wireless settings on
the connected device. Then start the network software to send images to your projector through a wireless
network.
c
To prevent the SSID and IP address from being displayed on the LAN standby screen or the Home
screen, set SSID Display and IP Address Display to Off.
s
Network - Network Configuration -
Wireless LAN p.67
To Next Page
Loading...
