Configuration Menu
68
Wired LAN menu
Function Menu/Settings Explanation
DHCP
On, Off
Set whether or not (On/Off) to use DHCP. If this
is set to On, you cannot set any more addresses.
IP Address
Number from 0 to 255 Enter the IP address assigned to the projector.
You can enter a number from 0 to 255 in each
field of the address. However, the following IP
addresses cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255
(where x is a number from 0 to 255)
Subnet Mask
Number from 0 to 255 Enter the projector's subnet mask.
You can enter a number from 0 to 255 in each
field of the address. However, the following sub-
net masks cannot be used.
0.0.0.0, 255.255.255.255
Gateway Address
Number from 0 to 255 Enter the projector's gateway IP address.
You can enter a number from 0 to 255 in each
field of the address. However, the following gate-
way addresses cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255
(where x is a number from 0 to 255)
IP Address Display
On, Off Set to Off to prevent the IP address from being
displayed on the Net. Info. - Wired LAN screen.
Others menu
Function Menu/Settings Explanation
PJLink Notification On, Off To use the notification function of PJLink, select
On.
Notified IP Address Number from 0 to 255 Enter the IP address of a computer to be notified
of the projector’s operating status using the
PJLink notification function.
You can enter numbers from 0 to 255. The fol-
lowing IP addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (x is a
number from 0 to 255)
AMX Device Dis-
covery
On, Off When you want to allow the projector to be de-
tected by AMX Device Discovery, set this to On.
Set this to Off if you are not connected to an en-
vironment controlled by a controller from AMX
or AMX Device Discovery.
Control4 SDDP
On, Off When you want to allow the projector to be de-
tected by Control4 SDDP, set this to On. Set this
to Off if you are not connected to an environ-
ment controlled by a controller from Control4 or
Control4 SDDP.
To Next Page
Loading...
