From Installation to Projection
This section explains the procedure for connecting the projector to a
computer with the computer cable and projecting images.
ON
a
Connect the projector to an electrical outlet with the power cord.
b
Connect the projector to the computer with the computer cable.
c
Turn on the projector.
d
Open the A/V mute slide.
e
Turn on your computer.
f
Change the computer's screen output.
When using a laptop computer, you need to change the screen
output from the computer.
Hold down the Fn key (function key), and press the b key.
a
• The method for changing differs depending on the computer being
used. See the documentation supplied with the computer.
• When turning off the projector, press the [t] button twice.
If the image is not projected, you can change the projected image using one
of the following methods.
• Press the [Source Search] button on the control panel or the remote
control.
s
"Automatically Detect Input Signals and Change the Projected Image
(Source Search)" p.29
• Press the button for the target port on the remote control.
s "Switching to the Target Image by Remote Control" p.30
a
After projecting the image, adjust the image if necessary.
s "Correcting Keystone Distortion" p.34
s "Correcting the Focus" p.41
Projecting Images
28
To Next Page
Loading...
Need help?
General
Weight and Dimensions
