4
Remove the screen first. If the stand is folded before removing the screen, it could fall and cause an injury.
1
Remove the screen.
1
Pull up the adjuster lever and lower the extension pole. Push down the adjuster lever after
lowering the extension pole.
2
Remove the shafts in reverse of the way they were installed.
2
Store the screen.
Roll up the screen without wrinkling it and
store it in the storage case.
Storing
4
Install the screen.
* The screen is wrapped around a core for transportation. Remove the core and discard it.
* The white part of the screen should be completely dried before shipping. When you use the screen for the
first time, you may notice a slight chemical odor. This odor will disappear while you use the screen. If the
odor is too strong, open up a window to ventilate the room and allow it to dry for a few days.
3
Store the stand.
1
Pull the shafts straight out from the holder. Hold the stand securely with one
hand.
2
Remove the stabilizer from the tripod. Step on the stabilizer and lean the stand
backward so that the stabilizer separates easily.
3
Pull up the tripod lever and fold the tripod.
4
Store the stand first, then the shafts, and stabilizer in that order. Make
sure the hooks at the tips of the shafts are facing outward.
* Store the screen, stand, and shafts correctly.
If it is not done correctly, the screen could get dirty or damaged.
1
Hook the screen on either side of two
shafts and spread the screen. The white
surface should be in front.
2
Hook the screen on the other two shafts.
Push the hooks slightly into the shafts to put
them into the holes on the screen easily.
5
Adjust the height of the screen.
1
Pull up the adjuster lever and slide the extension
pole up and down to adjust the height.
2
Push down the adjuster lever to secure
the extension pole.
* Raise the extension pole slowly when adjusting the height.
Be careful not to pull it too far or it may come out.
To Next Page
Loading...