■ ■ ■ ■
8
1. If you will be viewing the video on your computer
monitor as well as the projector screen, disconnect the
monitor cable from the video port on the back of your
computer.
2. Connect one end of the computer cable to the projector’s
Computer port.
3. Connect the other end of the computer cable to the
computer’s video port.
4. Tighten the screws on all connectors.
Connecting the Mouse Cables
If you want to use the remote control as a mouse, you need to
connect the PS/ 2 mouse cable or USB mouse cable.
♦ Note: The USB mouse port on the projector can only be used by
connecting a USB mouse. It is not possible to connect other USB
equipment for use.
Refer to this illustration while following the steps below.
Mouse/Com port
USB mouse cable
USB mouse port
PS/2 mouse cable
Downloaded from: http://www.usersmanualguide.com/
To Next Page
Loading...
