Epson EMP-822 - Removing the Engine;Boards

4-25
EMP-822/EMP-83/EMP-X5/EMP-S5
SEIKO EPSON Revision:A
4.4 Removing the Engine/Boards
4.4.1 Removing the Foot Detection Assy. (EMP-X5 only)
1).Disconnect the cable of the Foot Detection Assy. from the connector CN705 on the MA
Board.
2). Remove the two screws (C.B.P-TITE SCREW,3X10,F/ZB-3C) that secure the Foot
Detection Assy., and remove the Foot Detection Assy.
Figure 4-19.
Foot Detection Assy.