Epson EMP-822 - Removing Other Main Parts

4-43
EMP-822/EMP-83/EMP-X5/EMP-S5
SEIKO EPSON Revision:A
4.5 Removing Other Main Parts
4.5.1 Removing the Inner EX Duct A/Intake Fan/RC Board Assy.
 Removing the Inner EX Duct A
1).Remove the two screws (C.B.P-TITE SCREW,3X10,F/ZB-3C) that secure the Inner
Exhaust Duct A, and remove the Inner Exhaust Duct A.
 Removing the Intake Fan
1).Remove the five screws (C.B.P-TITE SCREW,3X10,F/ZB-3C) that secure the Intake
Duct, and remove the Intake Duct together with the Intake Fans.
2).Remove the four screws (two each: C.B.P-TITE SCREW,3X12,F/ZN-3C) that secure the
Intake Fans, and remove the Intake Fans from the Intake Duct.
3).Remove the Intake Fan Sheet (one each) from the Intake Fans.
 Removing the RC Board Assy.
1).Remove the RC Board Assy. from the Lower Case.
2).Remove the RC Cable from the RC Board Assy.
Figure 4-40.
Inner Exhaust Duct A
RC Board Assy.
RC Cable
Intake Fan
Intake Fan Sheet
Intake Duct