Epson EMP-830 Quick Reference Guide

5
Computer (Analog-RGB)
Video
S-Video
ComputerComputer
Easy MP
1. Press .
2. To view details of the image, switch to the active window.
Tilt to select an image and then press .
3. Project the images in the active window.
Press .
You may need to switch the output source on the computer.
Hold down the key and press the key (with a symbol
such as or on it).
Once the setting is changed, projection will start after a short period.
If you use any buttons to switch the input source, the preview
window will close and the selected images will be projected.
Computer documentation
User's Guide "Selecting an Image Source While
Viewing Projected Images (Preview Function)"
Press .
To select images to be
projected while viewing
all images being input...
(Preview Function)
To switch using the
remote control...
If the source does not
change to the laptop PC
connected by a
computer cable...
Active window
Move the
cursor to the
desired image.
If no signal is input,
the window will appear
blue.
EasyMP is only
displayed when using
the EMP-835.
Set mirror setting or
display detection.
Examples of changing output
NEC
Panasonic
TOSHIBA
IBM
SONY
FUJITSU
Macintosh
If images are not projected
even after carrying out the
above, press on the
remote control. Interactive
help will be displayed.
You can then answer the
questions to obtain the
optimum settings.
14
Disconnect the power cable from the electrical outlet.
Then contact your dealer or the nearest address provided in the "International Warranty
Conditions" section of the Safety Instructions/World-Wide Warranty Terms booklet.
Check if the lamp is broken.
Disconnect the power plug from the electrical outlet and wait for the lamp to cool down
sufficiently (takes about one hour) before checking.
p.16
Contact your local dealer for further advice.
If all indicators are switched off,
check that the power cable is
connected correctly and that
power is being supplied normally.
If the lamp is
not broken
If the lamp is
broken
When the Power indicator is lit/flashing red
Problem/Warning
Internal error
Lamp open error
Lamp timer failure
Lamp out
Lamp cover is open
Fan related error/
Sensor error
lit
flashing
off
Indicates the
operating status of
the projector
Indicates the internal
temperature status
Indicates the
lamp status
User’s Guide "Reading the Indicators"
Reading the Indicators
Red
Red
Red
The projector is provided with indicators to notify
you of the projector operating status.
The following tables show what the indicators
mean and how to remedy the problems that
they indicate.
Red
Red
Red
Red
If the problem is still not solved after the lamp is
replaced, stop using the projector and disconnect
the power cable from the electrical outlet. Then
contact your dealer or the nearest address
provided in the "International Warranty Conditions"
section of the Safety Instructions/World-Wide
Warranty Terms booklet.
Replace the
lamp and
then turn the
power on.
If the lamp
still does not
turn on,
replace it with
a new lamp.
404401202 BK 3-B Rev.2
404401202 DIC188 3-B Rev.2

Epson EMP-830 Specifications

General

Brand	Epson
Model	EMP-830
Category	Projector
Language	English