87
Maintenance
Take out the lamp.
Hold the lamp as shown in the illustration below and lift it up
and out of the projector.
If the lamp is broken replace it with a new lamp, or contact your
local dealer for further advice. If replacing the lamp yourself,
be careful to avoid pieces of broken glass.
Install the new lamp.
Insert the new lamp so that the lamp fits the place correctly and
once it is fully inserted, tighten the two screws.
Install the lamp cover.
Slide the lamp cover and tighten the cover fixing screws.
•Install the lamp securely. If the lamp cover is removed, the lamp
turns off automatically as a safety precaution. Moreover, the lamp
will not turn on if the lamp or the lamp cover is not installed
correctly.
•The lamp contains mercury. Dispose of used lamps properly in
accordance with your local regulations.
To Next Page
Loading...
