4-2
EMP-S4
SEIKO EPSON Revision:B
4.1 Overview
This chapter describes the procedures for disassembling and assembling the main components
of the EMP-S4 projector. Unless otherwise specified, reassembly is the reverse of the disas-
sembly procedure. Read the precautions described in the next section before starting.
4.1.1 Precautions
Some procedures require specific precautions that must be followed, and those will be noted
throughout this chapter. Note the following precaution definitions:
WARNING
CAUTION
REASSEMBLY
CHECK POINT
The precautions in the two lists below, WARNING and CAUTION, must always be followed
during disassembly and assembly. Before starting the disassembly work on this product, read
and follow these precautions.
W A R N I N G
Procedures which, if not strictly observed, could result in personal injury are
described under the heading WARNING
C A U T I O N
CAUTION signals a precaution which, if ignored, could result in damage to
equip-ment.
If assembly needs special attention or the procedure is different from the reversed
disassembly procedure, the correct procedure is described under the heading
REASSEMBLY.
C H E C K
P O I N T
Important tips for procedures are described under the heading CHECK POINT.
To Next Page
Loading...
