Epson EMP-S4 - Tools and Equipment

4-4
EMP-S4
SEIKO EPSON Revision:B
4.1.2 Tools and Equipment
The tools and equipment in the following table will be needed. All are commercially available,
and should be made ready beforehand.
*1 Recommendation Properties
Appearance : light milky white liquid
Specific gravity : 1.5-1.7
Flash point [ ℃] : non-flammable
Boiling point [ ℃] : 50-100
Major component : fluorocarbon type inactive liquid
Solubility in water : Nil
GWP : 500
ODP : 0
ex, Sankei Kagaku Co.,Ltd. SANKOL CFD-931Z (http//www.sankeikagaku.co.jp/)
Please inquire of EMPTechSupport mailbox when there is an uncertain point.
Table 4-1. Tools Needed
Name Application
Phillips screwdriver No. 0 Disassembling the Focus ring
Phillips screwdriver No. 2 (20 cm)
Disassembling the outer case and inner
components
Flathead screwdriver
Disassembling the rear foot and the
front foot
Flathead precision screwdriver Removing the front foot
Hexagonal box screwdriver (5 mm) Removing the computer interface
Brush Cleaning away dust
Vacuum cleaner Cleaning away dust
Lens cleaner Cleaning the projection lens
Air blower Cleaning the light valves and fans
Gloves Protection against sharp edges
Antislip and static protection
Grounding strap Anti-static protection
Heat-resistant tape Securing cables
Farst drying iubricant *1 Lever Zoom/Focus