4-9
EMP-S4
SEIKO EPSON Revision:B
4.2.1 Removing the Model Name Plate
Remove the EMP-S4 Model Name Plate.
4.2.2 Removing the Lamp Lid Assy and LAMP UNIT FOR AS
1. Remove the screw that secures the Lamp Lid Assy, and remove the Lamp Lid Assy.
2. Remove the two screws that secure the LAMP UNIT FOR AS, and remove the LAMP
UNIT FOR AS.
Figure 4-2.
4.2.3 Removing the Rear Foot/Rubber Foot
1. Pull and rotate the Rear Foot to remove the Rear Foot.
2. Press a screwdriver or similar tool into the small slot beside the Rear Foot and pry the
Rubber Foot out of the projector Lower Case Unit.
Figure 4-3.
Lamp Lid Assy.
LAMP UNIT FOR AS
Rubber Foot
Rear Foot
To Next Page
Loading...
