Epson EMP-S4 - Removing the RC Filter, SW Light Shade Sheet B, SW Board Assy,Sw Cable Au, SW Button, and LED Lens

4-13
EMP-S4
SEIKO EPSON Revision:B
4.2.7 Removing the RC filter, SW Light Shade Sheet B, SW Board Assy, SW
Cable Au, SW Button, and LED Lens
1. Detach the RC Filter from the Upper Case.
2. Remove the SW Light Shade Sheet B from the SW Board Assy.
3. Remove the 4 (C.C.P-TITE, 3x6, F/ZN-3C) screws to remove the SW Board Assy.
4. Unlock connector H179 and disconnect the SW Cable Au.
5. Remove the SW Button.
6. Remove the LED Lens.
Figure 4-9.
RC Filter
SW Board Assy.
SW Cable, Au
SW Button
SW Light Shade Sheet, B
LED Lens