Epson EMP-S4 - Page 76

4-14
EMP-S4
SEIKO EPSON Revision:B
C A U T I O N
 After connecting the SW Cable Au, aslant to fold and secure it with a piece of
heat resistant tape as shown in Figure 4-10. Make sure that the fold is kept 1
cm away from the SW Board Assy.
Figure 4-10.
 After connecting the SW Cable, be sure to secure the cable with a piece of
heat-resistant tape as shown in Figure 4-11.
Figure 4-11.
PRINTED CIRCUIT BOARD
ASSEMBLY; SW_R1
cable sw, Au
Heat-Resistant Tape
1cm
cable sw
Heat-Resistant Tape