Epson EMP-S4 - Page 82

4-20
EMP-S4
SEIKO EPSON Revision:B
3. Remove the EMI Control Sheet from the MA Board Assy.
4. Remove the (C.C., 3x6, F/ZN-3C) screw to remove the MA Board Assy.
Figure 4-19.
C A U T I O N
 When installing the MA Board Assy, pay attention to the followings.
1). Fix both the RC Cable B and the Intake Fan Cable with two pieces of
heat-resistant tape as shown in Figure 4-20.
Figure 4-20.
MA Board Assy.
EMI Control Sheet
Intake Fan Cable RC Cable; B