Epson EMP-S4 - Removing the if Case Set, RC Filter, and SW Light Shade Sheet B

4-23
EMP-S4
SEIKO EPSON Revision:B
4.2.10 Removing the IF Case Set, RC Filter, and SW Light Shade Sheet B
1. Remove the SW Light Shade Sheet B from the IF Case Set.
2. Remove the 2 (C.B.P-TITE, 3x10, F/ZB-3C) screws that secure the IF Case Set, disconnect
the Speaker Cable from connector CN1800 on the MA Board, and remove the IF Case Set
from the MA Board Assy.
3. Remove the Remote Control (RC) Filter from the IF Case Set.
Figure 4-24.
MA Borad Assy.
IF Case Set
Speaker Cable
RC Filter
CN1800
SW Light Shade Sheet, B