Epson EMP-S4 - Removing the Exhaust Fan Set, Outer Exhaust Duct, and Exhaust Fan B

4-30
EMP-S4
SEIKO EPSON Revision:B
4.2.17 Removing the Exhaust Fan Set, Outer Exhaust Duct, and
Exhaust Fan B
1. Remove the (C.B.P-TITE, 3x10, F/ZB-3C) screw that secures the Exhaust Fan Set and
remove it.
Figure 4-32.
C A U T I O N
 When installing the cable of both the Lamp Lid Detection Switch and the
Exhaust Fan, route them as shown in Figure 4-33.
Figure 4-33.
Exhaust Fan Set
Lamp Lid Detection Switch Cable Exhaust Fan Cable