4-31
EMP-S4
SEIKO EPSON Revision:B
2. Remove the two (C.B.P-TITE SCREW, 3x30, F/ZN-3C) screws that secure the Exhaust Fan
B, and remove the Outer Exhaust Duct from the Exhaust Fan Set.
Figure 4-35.
C A U T I O N
When installing the Ballast Cable, route the cable and move the ferrite core
into the position as shown in Figure 4-34.
Figure 4-34.
Ballast Cable Ferrite Core
Outer Exhaust Duct
Exhaust Fan, B
To Next Page
Loading...
