4-32
EMP-S4
SEIKO EPSON Revision:B
4.2.18 Removing the TH Board Assy, Cable RCR FIF, Lamp Lid Detection
Switch, and Inner Exhaust Duct
1. Remove the (C.C.P-TITE, 2x12, F/ZN-3C) screw that secure the Lamp Lid Detection
Switch, and remove the Lamp Lid Detection Switch from the Inner Exhaust Duct.
2. Remove the (C.C.P-TITE, 3x8, F/ZN-3C) screw that secures the TH Board Assy (Printed
Circuit Board Assy, TH_S2), and remove the TH Board Assy from the Inner Exhaust Duct.
3. Remove the Cable RCR FIF from the TH Board Assy.
4. Remove the (C.C.P-TITE, 3x8, F/ZN-3C) screw that secures the Lamp Connector, and
remove the Lamp Connector from the Inner Exhaust Duct.
5. Remove the 2 (C.B.P-TITE, 3x10, F/ZB-3C) screws to remove the Inner Exhaust Duct.
Figure 4-36.
Cable RCR, FIF
Inner Exhaust Duct
Lamp Lid
Detection Switch
Lamp Connector
TH Board Assy.
To Next Page
Loading...
