Epson EMP-S4 - AS (after Service) Menu; How to Display the as (after Service) Menu

5-2
EMP-S4
SEIKO EPSON Revision:B
5.1 AS (After Service) Menu
The AS (After Service) menu provides information and settings that are not displayed on the
standard menu.
5.1.1 How To Display the AS (After Service) Menu
Press the Menu button on either the remote control or the projector's control panel for at least 7
seconds. Within 4 seconds after pressing the Menu key, hit these buttons in order shown below
to display AS menu.
Esc → Esc → Tele → Wide
 When the video source is PC type, Component type, the following screen appears.
C A U T I O N
The contents of this chapter are for use only by Epson Authorized Servicers, and
are not to be disclosed to others without the express written consent of Epson.
Computer
Computer
Input Signal
Input Signal
: ---- (---- )
: ---- (---- )
Frequency
Frequency
: H 0.000kHz / V 0.000Hz
: H 0.000kHz / V 0.000Hz
Sync Polarity
Sync Polarity
: H -------- / V --------
: H -------- / V --------
Sync Mode
Sync Mode
: ----
: ----
Detected Comp Mode
Detected Comp Mode
: XXXXXXXXXXXXXXX
: XXXXXXXXXXXXXXX
Total Operation Time
Total Operation Time
: 0H
: 0H
Lamp Op. Time (C)
Lamp Op. Time (C)
: 0H
: 0H
(H/M/L)
(H/M/L)
: 0H / 0H / 0H
: 0H / 0H / 0H
Lamp Replacement
Lamp Replacement
: 0Times
: 0Times
Lamp ON/LampOFF
Lamp ON/LampOFF
: 0Times / 0Times
: 0Times / 0Times
Cool Down Completed
Cool Down Completed
: 0Times
: 0Times
Fatal Error
Fatal Error
: T 0 L 0 I 0
: T 0 L 0 I 0
Destination
Destination
: XXXXXXXX
: XXXXXXXX
Engine Type
Engine Type
: XXXXXXX
: XXXXXXX
P
P
XXXXXXXXXXXXXXX
XXXXXXXXXXXXXXX
O
O
------------------
------------------
J XXXXXXXXXXXXXXX
J XXXXXXXXXXXXXXX
The last four digits show the PW
firmware version.
The last four digits show the Y43
firmware version.
• Fatal Error: Abnormal termination
counter
Displays the number of times of each
of the following abnormal termina-
tions.
T: Temperature problem
L: Lamp problem
I: Internal problem
(Same as for S-Video and Video)