Epson EMP-S4 - Initializing (Resetting) the as Menu Values

5-3
EMP-S4
SEIKO EPSON Revision:B
 When the video source is Video type, the following screen is displayed.
5.1.2 Initializing (Resetting) the AS Menu Values
There are two levels of initialization that can be used to reset the projector usage history values
stored in EEPROM.
1. Clearing the Basic Lamp Information
While the AS menu is being displayed, simultaneously press the [Source] and [] keys for
10 seconds.
2. Clearing All the Lamp Information
While the AS menu is being displayed, simultaneously press the
[Source] and [] keys for
10 seconds.
Item
Clearing the Lamp Informa-
tion
Clearing All the Lamp
Information
Total Operation Time No Change Reset to 0H
Lamp Operation Time Reset to 0H Reset to 0H
Lamp ON Reset to 1 Reset to 1
Lamp OFF Reset to 0 Reset to 0
Lamp Replacement
Add 1 to the
current value
Reset to 0
Fatal Error (3 items) No Change Reset to 0
Computer
Computer
Video Signal
Video Signal
: ---- (No Signal )
: ---- (No Signal )
Total Operation Time
Total Operation Time
: 0H
: 0H
Lamp Op. Time (C)
Lamp Op. Time (C)
: 0H
: 0H
(H/M/L)
(H/M/L)
: 0H / 0H / 0H
: 0H / 0H / 0H
Lamp Replacement
Lamp Replacement
: 0Times
: 0Times
Lamp ON/LampOFF
Lamp ON/LampOFF
: 0Times
: 0Times
Cool Down Completed
Cool Down Completed
: 0Times
: 0Times
Fatal Error
Fatal Error
: T 0 L 0 I 0
: T 0 L 0 I 0
Destination
Destination
: XXXXXXXX
: XXXXXXXX
Engine Type
Engine Type
: XXXXXXX
: XXXXXXX
P
P
XXXXXXXXXXXXXXX
XXXXXXXXXXXXXXX
O
O
------------------
------------------
J
J
XXXXXXXXXXXXXXX
XXXXXXXXXXXXXXX
The last four digits show the PW
firmware version.
The last four digits show the Y43
firmware version.