Epson EMP-S5 - Page 67

4-18
EMP-822/EMP-83/EMP-X5/EMP-S5
SEIKO EPSON Revision:A
 When reassembling the SW Board Assy., be careful of the following.
• On the central part of the SW Board, fold the cable of the SW Board Assy., and
secure it with a
heat-resistant tape.
• Route the cable of the Shutter Switch as shown in the figure below, and fix it with
the
heat-resistant tape fixing the SW Board Assy.
Figure 4-11.
Shutter Switch Cable
SW Board