Epson EMP-S5 - Page 80

4-31
EMP-822/EMP-83/EMP-X5/EMP-S5
SEIKO EPSON Revision:A
• (1)’s Routing
1).Route the cable of the Lamp Lid Detection Switch under the MA Plate, and
through the slit shown in the figure below in the direction of the arrow.
2).Connect to CN700 on the MA Board Assy.
Figure 4-25.
• (2), (4)’s Routing
1). Route the Lamp Fan Cable twice around the Speaker Cable, then connect
the connector.
2). Route the Intake Fan1 Cable twice around the Intake Duct, then connect
the connector.
Figure 4-26.
Connector (CN700)
MA Plate
Lamp Lid Detection Switch
Intake Duct
Speaker Cable
Lamp Fan Cable
Intake Fan1 Cable