Epson EMP-S5 - Page 81

4-32
EMP-822/EMP-83/EMP-X5/EMP-S5
SEIKO EPSON Revision:A
• (5)’s Routing
1). Secure the RC Board Cable to the Intake Fan1 with a heat-resistant tape,
then route it twice around the Intake Duct, and connect the connector.
Figure 4-27.
• (6), (7)’s Routing
1). Route the Intake Fan2 Cable in between the protrusion of the Intake Duct
and the MA Board Assy.
2). When routing the SCI Cable, do not pull from the PS Ballast Assy. side.
Figure 4-28.
Intake Duct
Intake Fan1
RC Board Cable
Intake Duct
PS Ballast Assy.
SCI Cable
Intake Fan2 Cable