Epson EMP-S5 - Removing the PS Ballast Assy

4-47
EMP-822/EMP-83/EMP-X5/EMP-S5
SEIKO EPSON Revision:A
4.5.2 Removing the PS Ballast Assy.
 Removing the PS Ballast Assy.
1).Release the Ferrite Core and AC Inlet of the AC Cable from the Lower Case.
2).Remove the three screws (C.B.P-TITE SCREW,3X10,F/ZB-3C) that secure the PS Bal-
last Assy., and remove the PS Ballast Assy. from the Lower Case.
Figure 4-46.
This part is designated as the Safety Device. When removing/replacing the part
for repair, be sure to refer to the following section. According to the instructions
in it, handle the part and perform the procedure after servicing.
 4.1.4 "Safety Check after Servicing" (p. 4)
PS Ballast Assy.
Ferrite Core
AC cable
Lower Case
AC Inlet
Safety Switch