Epson EMP-X5 - Removing the Lamp Lid Detection Switch;Th Board Assy

4-35
EMP-822/EMP-83/EMP-X5/EMP-S5
SEIKO EPSON Revision:A
4.4.3 Removing the Lamp Lid Detection Switch/TH Board Assy.
 Removing the Lamp Lid Detection Switch
1). Remove the screw (C.P.P-TITESCREW,2.5X8,F/ZN-3C) that secures the Lamp Lid
Detection Switch, and remove the Lamp Lid Detection Switch.
 Removing the TH Board Assy.
1). Remove the screw (C.B.P-TITE SCREW,3X10,F/ZB-3C) that secures the TH Board
Assy., and remove the TH Board Assy.
Figure 4-31.
This part is designated as the Safety Device. When removing/replacing the part
for repair, be sure to refer to the following section. According to the instructions
in it, handle the part and perform the procedure after servicing.
 4.1.4 "Safety Check after Servicing" (p. 4)
C.P.P-TITESCREW,
2.5X8,F/ZN-3C
TH Board Assy.
Lamp Lid Detection
Switch