Epson EMP-X5 Service Manual

4-47
EMP-822/EMP-83/EMP-X5/EMP-S5
SEIKO EPSON Revision:A
4.5.2 Removing the PS Ballast Assy.
 Removing the PS Ballast Assy.
1).Release the Ferrite Core and AC Inlet of the AC Cable from the Lower Case.
2).Remove the three screws (C.B.P-TITE SCREW,3X10,F/ZB-3C) that secure the PS Bal-
last Assy., and remove the PS Ballast Assy. from the Lower Case.
Figure 4-46.
This part is designated as the Safety Device. When removing/replacing the part
for repair, be sure to refer to the following section. According to the instructions
in it, handle the part and perform the procedure after servicing.
 4.1.4 "Safety Check after Servicing" (p. 4)
PS Ballast Assy.
Ferrite Core
AC cable
Lower Case
AC Inlet
Safety Switch

Epson EMP-X5 Specifications

General

Resolution	1024 x 768 (XGA)
Contrast Ratio	400:1
Lamp Life	3000 hours (Normal Mode), 4000 hours (Eco Mode)
Display Technology	3LCD
Zoom Ratio	1.2x
Projection Size	30 - 300 inches
Brightness	2200 lumens
Weight	2.7 kg
Inputs	Composite video, S-Video
Noise Level	35 dB (standard), 28 dB (economy)