Epson EPL-6200 - Page 171

EPSON EPL-6200/EPL-6200L Revision A
Adjustment Feed Registration Adjustment 171
7. If the position is shifted, input the measured distance value in [Input] box and click
[Input] button to store the value on the main controller.
8. Click on [Print] button to print the pattern again with the specified correction value. If
further adjustment is required, go to <step 6> to repeat adjustment.
9. When the adjustment is finished, click on [Quit] button to terminate the program.
10. Turn off the printer.
C A U T I O N
 Verify the registration position at both left and right side of the
pattern.
 When printing a test pattern chart, make sure that the edge
guide of paper tray is properly aligned against the edge of paper
in order to avoid possible skew with fed paper.
C A U T I O N
If the input value is within the tolerance of adjust value, the
program displays a message and the value on the main controller
remains unchanged.