Epson EPL-6200 - Network Setup Menu

Tips for Administrator 172
Network Guide
8. Select PANEL, then press the Enter button. Press the Left button to return to the
NETWORK SETUP menu.
9. Press the Down button to select IP, SM, or GW, then press the Right button.
10.Press the Up or Down button on the IP ADDRESS screen until the desired value
appears. Then press the Right button.
11.Press the Up or Down button on the SUBNET MASK screen until the desired value
appears. Then press the Enter button.
12.Press the Up or Down button on the DEFAULT GATEWAY screen until the desired value
appears. Then press the Enter button to set the values.
13.Press the Left button twice to exit the control panel menus.
14.Turn off your printer and then turn it back on. Be sure to wait until the initialization is
complete.
Print a network status sheet to confirm the new IP address.
Note:
❏ You must first set the IP address before using EpsonNet Config with Web Browser.
❏ See the User’s Guide for more information about settings on the printer’s control panel.
Network Setup Menu
These items are used to make network settings on the printer’s control panel.
* Available only when Enable is selected for NETWORK SETUP.
Item Settings (default in bold)
NETWORK SETUP Disable, Enable
IP ADDRESS
SETTING*
Auto, Panel, PING
IP* 0.0.0.0 to 255.255.255.255
SM* 0.0.0.0 to 255.255.255.255
GW* 0.0.0.0 to 255.255.255.255
AppleTalk* On, Off
MS Network* On, Off
Bonjour* On, Off
INIT NETWORK
SETTING*
EXECUTE