Epson EPL-N4000 - Page 68

3-20
Options
Flamingo
Rev. C
A5 size OPTIONS.FM
11/5/98 Pass 0
L
Proof Sign-off:
M.Takata _______
K.Nishi _______
K.Pipa _______
After installing
1. Reconnect any interface cables you removed.
2. Make sure the printer is turned off. Plug the power cord into
an electrical outlet.
3. Turn on the printer.
4. On the control panel’s Setup Menu, set Face-up Enable to
On. See “Using SelecType” on page 4-3.
To confirm that the Face-up Tray is installed correctly, print a
status sheet. If the tray is not listed on the status sheet, try
reinstalling it.
Note:
When replacing the imaging cartridge or clearing a paper jam, make sure
to temporarily remove the Face-up Tray before opening cover A.
To temporarily remove the Face-up Tray, tilt it upward and lift up.