Epson EPL-N4000 - Page 226

EPSON EPL-N4000/EPL-N4000+ Chapter 4 Disassembly and Assembly
Rev.B 212
6. Disconnect J205 from the Main Motor PWB.
7. Release the wire harness that is located just above the Main Motor
PWB from the wire clip and move the harness out of the way.
8. Remove the screw securin
g
the
g
reen
g
round wire to the Main Drive
Assembly, and move the
g
round wire out of the way (Fi
g
ure below).
Figure 4-78. Removal of Main Motor PWB
9. Disconnect P/J 462 from the MCU PWB.
10. Disconnect P/J 202, J209, J600, and J601.
11. Remove the three screws securin
g
the Harness Support to the Main
Drive Assembly, and move the Harness Support and attached
harness out of the way.
12. Remove the three self-tappin
g
screws securin
g
the Main Drive
Assembly to the printer frame. The bottom ri
g
ht screw also secures
a
g
round wire (with attached resistor) to the printer frame.
13. Remove the screw that secures a
g
round strap at the bottom left of
the Main Drive Assembly.
14. Lift the Exit Gear out of the way, and pull the Main Drive Assembly
strai
g
ht back and out of the printer frame.
CHECK
POINT
If you are having difficulty removing the Main Drive
Assembly, check to make sure there are no wire
harness in the way, the Registration Clutch location
notch in not in the way, and that the drive pin on the
Drive Assembly is in the center of the cutout in the
printer frame.