Epson EPL-N4000 - Page 51

EPSON EPL-N4000/EPL-N4000+ CHAPTER 1 Product Description
Rev.B 37
printin
g
up to a quantity of 10 can be exceeds 10, a quantity of 1 only is
ejected to Multibin 1 and the messa
g
e “Collate was disabled” is
displayed.
If Sorter is selected when the Multibin settin
g
is MultiSort, printin
g
takes
place by chan
g
in
g
the multibin paper eject destination for each quantity.
Quantity is set with EJL or ESC/Pa
g
e. Paper ejection is carried out in
the order of Multibin 1, 2, 3...When Multibin 10 is reached, paper
ejection be
g
ins from Multibin1 a
g
ain. If the specified quantity cannot be
implemented due to insufficient memory, a quantity of 1 only is ejected
to Multibin 1 and the messa
g
e “Colla
g
e was disabled” is displayed.
For mailbox bin selection, only one of 1 to 10 can be selected with the
panel and PJL or EJL. More than one bin can be selected with the ESG/
Pa
g
e command.
If an item, which cannot be selected due to the operation mode of the
paper eject unit, is specified by the ESC/Pa
g
e command, that
specification only is i
g
nored and paper is ejected to the place specified
on the panel.
PAPER EJECT PORT SELECT SPECIFICATIONS

Multibin:
When Multibin=Stacker, Out Bin=Stacker:
The paper eject destinations are in the order of (Multibin’s) bin 10,
bin 9...bin1, Face-down. For the first time after the power is turned
on, the pro
g
ram looks for a paper-eject full bin starin
g
from Multibin
1 and be
g
ins paper ejection from a bin precedin
g
the full bin. For the
second time and subsequent, paper ejection be
g
ins from the last
paper ejected bin. After there is not any full bin, paper ejection
be
g
ins from Multibin 10. Whether or not Face-down is used when
the last bin becomes full is determined by the panel settin
g
“Stacker”. If Stacker=+Face-down, Face-down is used. If
Stacker=No Face-down, Face-down is not used.
Stacker=+Face-down : bin 10>bin 9>...>bin 1>Face-down
Stacker=No Face-down : bin 10>bin 9>...bin1 (valid with EPL-
N4000+)

Finisher (valid with EPL-N4000+):
When Out Bin= Stacker:
The paper eject destination are in the order of bin 1>bin 2>bin
3>Face-down.
For the first time after the power is turned on,
a paper not empty bin is searched for from bin 3 to bin 1 to start
paper ejection.
For the second time and subsequent,
a paper not empty bin is searched for from the previously paper
ejected bin to start paper ejection. After there is no full bin, paper
ejection starts from bin 1.
Whether or not Face-down is used when the last bin becomes full is
determined by the panel settin
g
“Stacker”.
If Stacker=+Face-down:
Face-down is used without staple desi
g
nation.
The error “Finisher 3 Full” occurs and Face-down is not
used with staple desi
g
nation.
If Stacker=No Face-down,
the error “Finisher 3 Full” occurs and Face-down is not used.